Cub Cadet RT 75 - Manual (Page 49)

Swivel Handle
45
NOTE: There is a nut retension bracket on the left side of
the handle bar swivel mount. When the handle
mounting nut and bolt is removed, the bracket and
the upper nut will fall off. See Figure 8.6.
8. Remove the handle mounting nut and bolt.
9. Remove the handle bar from the machine.
10. If replacing the handle bar:
10a. Remove the forward drive bail.
10b. Remove the reverse lever.
10c. Remove the front cover and swivel rod bracket.
11. Install the handle bar by following the previous steps
in reverse order.
12. Test run the unit in a safe area before returning it to
service.
Figure 8.6
nut retension bracket