Cub Cadet RT 75 - Manual (Page 33)

Transmission Overhaul
29
15. Remove the four hex flange screws holding the rear
transmission cover to the transmission housing,
using a 1/2” wrench. See Figure 6.6.
16. Wedge a sharp 5-in-1 painters tool or putty knife in
between the cover and the transmission housing.
17. Pry the cover off.
18. Clean the gasket from the rear transmission housing
and cover.
NOTE: The rear cover does not have a fill plug.
19. Remove the tine shaft oil seals from the transmission
housing . See Figure 6.7.
20. Remove the snap rings that secure the tine shaft
bearings, using a pair of snap ring pliers.
See Figure 6.8.
21. Push the tine shaft to the right, forcing the right tine
shaft bearing out of the transmission housing.
NOTE: The bearing is a slip fit. If it is stuck, use a block of
wood and a large hammer.
NOTE: The washer will be damaged by the Hi-Pro key.
22. Remove the bearing and washer from the right side
of the tine shaft.
23. Slide the tine shaft back into the housing until the Hi-
Pro key contacts the tine shaft worm gear.
24. Rotate the tine shaft until the Hi-Pro key slides into
the worm gear keyway.
Figure 6.6
Rear transmission cover
Figure 6.7
Thexton seal removal tool
Figure 6.8
Snap ring