Cub Cadet 600 series - Manual (Page 8)

500 and 600 SERIES 2-STAGE SNOW THROWER
4
4.4. Work the belt off the bottom of the drive plate by
rolling it between the drive disc and drive plate.
See Figure 4.4.
4.5. Pull the belt up through the top of the belt hous-
ing.
4.6. Examine the removed belt: If it failed because of
something other than normal wear, identify and
correct the cause before returning the snow
thrower to service.
4.7. Install new belt by reversing the removal procee-
dure.
4.8. Run/.test/adjust the traction drive belt before
returning the snow thrower to service.
5. AUGER CLUTCH CONTROL CABLE
5.1. The auger control is on the left side of the handle
bars.
5.2. Place a mark on the adjustment bracket to the
frame.White out or a grease pencil would be
good because it is easily removed.
See Figure 5.2.
5.3. Loosen the hex screws securing the adjust-
ments bracket to release tension off of the
cables.
5.4. Detach the z-fitting end of the cable from the
control handles with a pair of needle nose pliers.
See Figure 5.4.
5.5. Loosen the cable guide pulleys on the adjust-
ment bracket and slip the cable out of the pulley
groove.
Figure 4.4
Figure 5.2
Figure 5.4