Cub Cadet 600 series - Manual (Page 15)

500 and 600 SERIES 2-STAGE SNOW THROWER
11
11.7. Remove the four screws that hold the right side
Planetary gear housing.
11.8. In order to remove the housing it may be neces-
sary to squeeze the steering trigger to release
the dogg assembly from the planetary ring gear.
11.9. Rotate the entire friction assembly backwards to
free the pin from the slide shifter.
See Figure 11.9.
Figure 11.7
Figure 11.9
11.10. Maneuver the entire drive assembly to the left,
pivot the right side out of the frame and pull the
drive assembly out from the right side. See
11.10..
11.11. The complete drive assembly has two housings
on each side commonly referred to as gear clus-
ters. See Figure 11.11.
NOTE: Each drive gear drives one half of the
axle.
Figure 11.10
Figure 11.11
Planetary gear sets
Drive Gears