Cub Cadet 600 series - Manual (Page 22)

500 and 600 SERIES 2-STAGE SNOW THROWER
18
15.11. Remove the wing nut and screw directly in front
of the clevis pin,
15.12.Remove the shoulder bolt that secures the pul-
ley cover to the upper discharge chute.
15.13.The upper discharge chute will lift off of the lower
chute. See Figure 15.13.
NOTE: There are no chute flange keepers use
on models with the joystick chute control.
15.14.Remove the nut that secures the chute tilt cable
guide with a 1/2” socket. See Figure 15.14.
15.15.Remove the anti-pivot screw located on the
inside of the chute with a 3/8” socket.
Figure 15.10
Bow Tie
Cotter Pin
Wing Nut
Figure 15.12
1/2”
Socket
Figure 15.13
Figure 15.14
1/2” Socket