Cub Cadet 600 series - Manual (Page 19)

500 and 600 SERIES 2-STAGE SNOW THROWER
15
14.5. Remove the bolt that attaches the auger pulley
to the auger shaft with a 9/16” wrench. See Fig-
ure 14.5.
14.6. The pulley adaptor should slide off of the shaft
easily. See Figure 14.6.
Figure 14.5
Figure 14.6
14.7. Remove the screws holding the Bearing housing
on each side. See Figure 14.7.
NOTE: This is a good opportunity to inspect the
auger bearing for signs of wear.
14.8. Pull the Auger from the housing slight rotation of
the assembly may be necessary to pull the
impeller shaft clear of the rear bearing. See Fig-
ure 14.8.
NOTE: The most common cause of auger gear-
box damages impact with solid objects obscured
by snow fall.This damage is not warrantable.
Use of proper shear pins helps prevent gearbox
damage, but does not guarantee protection.
Figure 14.7
Figure 14.8