Cub Cadet 5000 Series - Manual (Page 5)

1
1. FENDER, FLOOR AND ROPS REMOVAL
1.1. Remove the brake, forward and reverse pedals
using a 9/16 socket.
1.2. Remove the differential lock pedal.
Figure 1.1
Reverse
Forward
Pedal
Pedal
Brake
Pedal
Figure 1.2
E Ring
1.3. Remove the dash extension.
1.4. Remove the foot pads from the running boards.
1.5. Remove the ROP’s using a 3/4 socket.
1.6. Remove the four screws securing the seat to the
seat rails using aT27 torx.
1.7. Remove gas cap and disconnect the seat safety
switch.
1.8. Remove rubber handle from left side high / low
range lever and from right side PTO lift lever.
Figure 1.3
Dash
Extension
Figure 1.7
Screws in
Seat Rails
Wiring Harness
To Seat Safety
Switch
Series 5000