Brake adjustment, Series 5000 – Cub Cadet 5000 Series User Manual
Page 26
Series 5000
22
5.45. The brake shaft can be lifted out of the transmis-
sion if the brake assembly is removed from the
other end of the shaft, and the transmission is
completely empty of oil.
6.
BRAKE ADJUSTMENT
6.1.
Raise the rear of the tractor and safely support it
with jack stands.
6.2.
Remove the rear tires.
6.3.
Disconnect the brake rods by removing the hair-
pin clips that connect the ferrules at the front of
each brake rod to the arms on the brake shaft
assembly.
6.4.
Insert a 0.010” feeler gauge between either
brake rotor and brake pad. Loosen or tighten the
adjustment nut on the brake caliper as neces-
sary using a 1/2” wrench.
NOTE: There are two brake rotors and three
brake pads on each side of the tractor.
Figure 6.3
Ferrule
Brake rod
Adjustment
nut on
brake
caliper
Figure 6.4
Figure 6.4
Brake
Rotors
- 7284 (52 pages)
- 7284 (89 pages)
- 72-inch (32 pages)
- ST23 (42 pages)
- 18.5HP Z-Force 42 (56 pages)
- TANK M54 (4 pages)
- LT1024 (28 pages)
- LT1024 (28 pages)
- 454 (20 pages)
- LT1050 (40 pages)
- 23Hp Tank 23BB5DBW150 (32 pages)
- 190-670-100 (12 pages)
- 01008371 15HP Z-Force 44 (54 pages)
- CC 500 (2 pages)
- CC4065 (44 pages)
- 190-192-190 (12 pages)
- PR-521 (16 pages)
- I1042 (36 pages)
- I1042 (56 pages)
- 439 (16 pages)
- 1000 Series (1 page)
- Fabricated Deck InDirect Injection Diesel (32 pages)
- 20HP ENFORCER 44 EN (32 pages)
- Z-FORCE 48 (2 pages)
- 7252 (48 pages)
- 7252 (52 pages)
- EX SERIES EX2900 (2 pages)
- THE TANK M48 (4 pages)
- H 1748 (2 pages)
- CC4025 (88 pages)
- LT1022 (28 pages)
- E977C (36 pages)
- RZT 50VT (2 pages)
- RZT 50 (56 pages)
- Series 390 (20 pages)
- 53AB5JEX750 (36 pages)
- 8354 (56 pages)
- 8404 (289 pages)
- EX450 (4 pages)
- 53AJ8CTX750 (32 pages)
- 7232 D (2 pages)
- Ex32002 (182 pages)
- 5254 (52 pages)
- Time Saver (16 pages)
- Zero-Turn Commercial Riding Mower Professional Turf Equipment (36 pages)