COP-USA DVRPRO04 - Manual (Page 52)

47
Chapter 8
Alarm Voice Triggering
The Alarm Voice setting will provide a voice warning message to users at
the time of detecting the alarm condition. Follow the instructions below to set
the Alarm Voice:
1. Click the Alarm tab and select the appropriate triggering event for
alarm recording Camera , Din , or Disk full , Disk failure ,
or No signal .
2. Specify the desired Trigger Period .
3. Click the Voice Tab and type in the Telephone Number ;
specify the area code if it is a long distance call, and if an extension
number is required, please add ,,, followed by the extension
number. A total of 14 bytes may be used.
4. Delay seconds means how many seconds you d like to delay before
the Alarm Voice is activated. A period of 1 to 10 seconds may be set
see picture below .
5. Repeat Times is used to set the number of times you d like to
trigger the alarm; 1 to 10 times can be set see picture below .
Figure 8-7: Voice Tab
6. Then click Add ; the drop-down window will show Voice
with the selections made.
7. Click Apply , and OK .
Alarm Fax Triggering
The Alarm Fax setting will allow a fax warning message to be sent at the
time of detecting an alarm condition. Follow the instructions below to set up
Alarm Fax:
1. Click the Alarm tab and select the appropriate triggering event for
alarm recording Camera , Din , or Disk full , Disk failure ,
or No signal .
Telephone Number
Delay