COP-USA DVRPRO04 - Manual (Page 50)

45
Chapter 8
Alarm Sound Triggering
Activating the Alarm Sound parameter enables sounding of the alarm at the
time of alarm condition detection. Follow the instructions below to set the
Alarm Sound.
1. Click the Alarm Tab first.
2. Select the Camera , Din , Disk full , Disk failure , or No
signal .
3. Select Enable or Enable Trigger Period .
4. Click the Sound Tab.
Figure 8-3: Sound Tab
5. Click the Select button to choose alarm sound from the sound list
window.
Figure 8-4: Sound Selection Window
6. Choose a .wav file from the above window and click OK
7. Click Play to play the file.
8. Select how many times you would like to repeat the alarm sound up
to 10 times