COP-USA DVRPRO04 - Manual (Page 51)

46
9. Then click Add .
10.Click Apply , and OK .
Alarm Message Triggering
Alarm Message may show additional information at the time of detecting
the alarm condition. Follow the instructions below to set the Alarm Message.
1. Click the Alarm Tab first.
2. Select the Camera , Din , Disk full . Disk failure , or No
Signal .
3. Select a Trigger Period .
4. Click the Message Tab.
Figure 8-5: Message Tab
5. Then click Add , the window below will show Message
6. Click Apply , and OK .
Once this function is enabled and users have enabled Motion Detection on
that particular camera, a pop-up screen will appear (as below) to warn
users that the DVR has detected motion.
Figure 8-6: Message Pop-up Warning
7. Then users may click the Confirm button.