COP-USA CD66MK-HW - Manual (Page 20)

- 17 -
Ⅳ Ⅳ Ⅳ Ⅳ. Description of Installation
4.1 Safety Measure
4.1.1 The requirement of the installation and service personnel.
With the qualifications of the CCTV system installation, high-altitude operation and other related
certifications.
With the basic knowledge and operation skill of the low voltage wiring and Low voltage
electronic circuit wiring.
With the ability to spell over this manual.
4.1.2 The requirement of the lifting appliance.
To be suitable for the installation place and dome installation.
With the good safety capability.
4.2 Warning
To prohibit to install and use this product near the flammable and explosive materials.
Please abide the national and regional electric safety regulations.
To be sure the power supplies have been disconnected during the installing of the products.
12VDC is the standard input voltage of this product, do not take the higher voltage to connect
with this product.
Do not install this product in the place where the ambient is too severe to use this product.
4.3 Ambient requirement
Indoor dome camera:
Ambient
Temperature
0
～+40
Humidity 10-75% (without agglomeration)
Atmospheric
pressure
86
～106KPa
Power supply DC12V/2.5A
Outdoor dome camera:
Ambient
Temperature
-35
℃～+55℃
Humidity 10-75% (without agglomeration)
Atmospheric
pressure
86
～106KPa
Power supply DC12V/2.5A