Checkline CAP-TT01 User Manual

Page 24

Series TT01 Digital Cap Torque Testers

User’s Guide

Use the UP and DOWN keys to select the correct password, then press ENTER to continue.

If the incorrect password has been entered, the display appears as follows:

To re-enter the password, press ESC to exit to the home screen. Then, access the desired function and
enter the password again when prompted.

If the password has been misplaced, it can be reset. Press ENTER to generate a request code. The
request code

must be supplied to Mark-10 or a distributor, who will then provide a corresponding

activation code

. Enter the activation code to disable the password.

15 OTHER SETTINGS

15.1 Automatic Shutoff
The tester may be configured to automatically power off following a period of inactivity while on battery
power. Inactivity is defined as the absence of any key presses or load changes of 100 counts or less. To
access these settings, select Automatic Shutoff from the menu. The display appears as follows:

Select Disabled to disable automatic shutoff. Select Enabled to enable it. The length of time of inactivity
is programmed in minutes via the Set Minutes parameter. Available settings: 5-30, in 5 minute
increments.

Note: If the AC adapter is plugged in, the tester will ignore the Automatic Shutoff setting and remain
powered on until the POWER key is pressed.

15.2 Backlight
Although the backlight may be turned on and off at any time by pressing the BACKLIGHT key, there are
several available initial settings (applicable upon powering on the tester). To access these settings, select
Backlight from the menu. The display appears as follows:

ENTER PASSWORD

(0000 – 9999)

5000

INCORRECT PASSWORD

Reset password

Request code:

XXXX

Press ENTER or ESC

AUTOMATIC SHUTOFF

Disabled

Enabled
Set Minutes