Checkline CAP-TT01 - Manual (Page 18)

Series TT01 Digital Cap Torque Testers User’s Guide
17
RS232/USB Output Outputs data via the serial and USB ports
Mitutoyo Output Outputs data via Mitutoyo (Digimatic) through the serial port
Memory Storage Stores a reading to memory (refer to the Memory section for details)
Any combination of the above functions may be selected.
12.5 I/O Connector Pin Diagram (female)
* The output assignments
depend on
several factors described in the table below. Output functions always reference the primary reading on
the display, regardless of the current mode.
Torque Pin 11 Pin 12 Pin 13
Upper and Lower Set Points are Clockwise
Greater than or equal to upper set point On Off Off
Between upper and lower set points Off Off On
Less than or equal to lower set point Off On Off
Upper and Lower Set Points are Counter-clockwise
Greater than or equal to upper set point Off On Off
Between upper and lower set points Off Off On
Less than or equal to lower set point On Off Off
Upper Set Point is Clockwise, Lower Set Point is Counter-clockwise
Greater than or equal to upper set point, in clockwise Off On Off
Between upper and lower set points Off Off On
Greater than or equal to lower set point, in counter-clockwise On Off Off
Upper Set Point is Counter-clockwise, Lower Set Point is Clockwise
Greater than or equal to upper set point, in counter-clockwise Off On Off
Between upper and lower set points Off Off On
Greater than or equal to lower set point, in clockwise On Off Off
Pin No. Description Input / Output
1 Signal Ground ---
2 Counter-clockwise Overload Output
3 RS-232 Receive Input
4 RS-232 Transmit Output
5 +12V DC Output
6 Analog Output Output
7 Clockwise Overload Output
8 Mitutoyo Clock
Output Bit 2
Output
9 Mitutoyo Data
Output Bit 0
Output
10 Mitutoyo Request
Input Bit 3
Input
11 * Set Point Pin 1 * Output *
12 * Set Point Pin 2 * Output *
13 * Set Point Pin 3 * Output *
14 Do not connect ---
15 Mitutoyo Ready
Output Bit 1
Output