Checkline CAP-TT01 User Manual
Page 17
Series TT01 Digital Cap Torque Testers
User’s Guide
16
Selection Description
Numeric + Units
Output format includes the value and unit of measure. Clockwise values have
positive polarity, counter-clockwise values have negative polarity.
Numeric Only
Output format includes the value only. Polarity same as above.
Invert Polarity
Clockwise values have negative polarity, counter-clockwise values have positive
polarity. May be selected in addition to the Numeric + Units / Numeric Only
selection.
Omit Polarity
Both directions are formatted with positive polarity. May be selected in addition to
the Numeric + Units / Numeric Only selection.
12.1.3 Data Communication
Individual data points may be transmitted by pressing DATA. Series TT01 testers will also respond to the
following ASCII commands:
?
Request the displayed reading
MEM
Transmit all stored readings
STA
Transmit
statistics
All commands must be terminated with a Carriage Return character or with a Carriage Return/Line Feed
combination. The tester’s responses are always terminated with a Carriage Return/Line Feed.
Any detected errors are reported back by means of error code *10 (illegal command).
12.2 Mitutoyo BCD settings
This output is useful for connection to data collectors, printers, multiplexers, or any other device capable
of accepting Mitutoyo BCD data. Individual data points may be transmitted by pressing DATA or by
requesting it from the Mitutoyo communication device (if available). To enable Mitutoyo output, select the
desired format – either with polarity or without polarity. The display appears as follows:
12.3 Analog Output
This output can be used for chart recorders, oscilloscopes, data acquisition systems, or any other
compatible devices with analog inputs. The output produces ±1 volt at full scale of the instrument. The
polarity of the signal is positive for clockwise and negative for counter-clockwise.
12.4 DATA Key Settings
To configure the functions of the DATA key, select DATA Key from the menu. The display appears as
follows:
DATA KEY
*
RS232/USB Output
Mitutoyo Output
Memory Storage
MITUTOYO BCD
*
Disabled
Enabled
* Without Polarity
With Polarity