beautypg.com

Compliances, Ompliances – ALFA NETWORK AIP-W505 User Manual

Page 3

background image

– 3 –

C

OMPLIANCES

F

EDERAL

C

OMMUNICATION

C

OMMISSION

I

NTERFERENCE

S

TATEMENT

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one of the following

measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected

Consult the dealer or an experienced radio/TV technician for help

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate

this equipment.

IEEE 802.11b or 802.11g operation of this product in the U.S.A. is

firmware-limited to channels 1 through 11.

IMPORTANT NOTE:
FCC R

ADIATION

E

XPOSURE

S

TATEMENT

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and

operated with minimum distance 20 cm between the radiator and your

body.