ALFA NETWORK AIP-W505 - Manual (Page 21)

C HAPTER 1 | Introduction
Hardware Description
– 21 –
E THERNET WAN P ORT
A 100BASE-TX RJ-45 port that can be attached to an Internet access
device, such as a DSL or Cable modem.
E THERNET LAN
P ORTS
The 11n Router has four 100BASE-TX RJ-45 ports that can be attached
directly to 10BASE-T/100BASE-TX LAN segments.
These port support automatic MDI/MDI-X operation, so you can use
straight-through cables for all network connections to PCs, switches, or
hubs.
P OWER C ONNECTOR
The 11n Router must be powered with its supplied power adapter. Failure
to do so results in voiding of any warrantly supplied with the product. The
power adapter automatically adjusts to any voltage between 100~240
volts at 50 or 60 Hz, and supplies 5 volts DC power to the unit. No voltage
range settings are required.
Table 2: LED Behavior
LED Status Description
Power On Blue The unit is receiving power and is operating
normally.
Off There is no power currently being supplied to
the unit.
WLAN On/Blinking Blue The 802.11n radio is enabled and
transmitting or receiving data through wireless
links.
Off The 802.11n radio is disabled.
WPS Blinking WPS authentication is in progress.
Off WPS authentication is not in progress.
WAN On Blue The Ethernet WAN port is aquiring an IP
address.
Blinking The Ethernet WAN port is connected and is
transmitting/receiving data.
Off The Ethernet WAN port is disconnected or has
malfunctioned.
LAN1~LAN4 On Blue The Ethernet LAN port is connected to a PC or
server.
Blinking The Ethernet port is connected and is
transmitting/receiving data.
Off The Ethernet port is disconnected or has
malfunctioned.