ALFA NETWORK AIP-W505 - Manual (Page 117)

– 117 –
A
T
ROUBLESHOOTING
D IAGNOSING LED I NDICATORS
I F Y OU C ANNOT C ONNECT TO THE I NTERNET
Check the following items:
◆ Check that your computer is properly configured for TCP/IP.
◆ Make sure the correct network adapter driver is installed for your PC
operating system. If necessary, try reinstalling the driver.
◆ Check that the network adapter’s speed or duplex mode has not been
configured manually. We recommend setting the adapter to auto-
negotiation when installing the network driver.
Table 4: LED Indicators
Symptom Action
Power/LAN LEDs are off ◆ The AC power adapter may be disconnected. Check
connections between the 11n Router, the power adapter, and
the wall outlet.
WLAN LED is off ◆ The access point radio has been disabled through it’s web
management interface. Access the management interface
using a web browser to enable the radio.
LAN LEDs are off
(when port connected)
◆ Verify that the 11n Router is powered on.
◆ Be sure cables are plugged into both the 11n Router and
corresponding PC.
◆ Verify that the proper cable type is used and its length does
not exceed specified limits.
◆ Check the cable connections for possible defects. Replace the
defective cable if necessary.
WAN LED is off ◆ There is no detected signal from WAN port. Check
connections and the management interface.