Panasonic NV-SD10 Series - Manual (Page 31)

Timer Recording
Setting Timer Recordings from Bar
Codes
Successively scan the data for the programme position
(channel), day, starting time and ending time by tracing bar
codes 2 to 4 on the programming sheet.
CANCEL
Preparation
Turn on the VTR and the remote controller.
For Example:
Programme position (channel); 4
Date;
3rd, November
Starting time: 20:02
Ending time; 21:30
(Present date; 16th, October)
Operations
1 Trace the bar code for CHANNEL “4”
(1) CHANNEL
&
Trace the bar code for DATE “3”.
H r. ^
3 Set Starting time.
• Trace the bar code fnr i Trace the bar code for START TIME “20”.
i3;START TIME
0Q-
H 3/
at OFT'
BQSO.
o
»Trace the bar code for MIN “2”.
&
Set Ending time.
• Trace the bar code for END TIME “21 ”.
#
4)ENDTIME
-v
iim
The repeated bleep sound indicates readiness for
data transmission to the VTR.
•Trace the bar code for MIN “30”.
fi-
À'i/W
€'
The bleep sound will be heard again.
5 To transmit the data to the VTR, press
TRANSMIT toward the VTR.
A
TRANSMIT
o
•The transmitted data appears on the display of the
VTR and a bleep sound confirms proper reception.
Programming a Series Timer Recordings
Trace the CANCEL bar code.
Repeat the required steps 1 to 5 for each timer
recording.
0 To turn off the remote controller, press ^
SCANNER ON/OFF.
SCANNER
ON-OF*^
o
32