Bar code operation, Operating the remote controller, When the bar codes cannot be read – Panasonic NV-SD10 Series User Manual
Page 29: Reading the bar codes, Scanner preparation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Bar Code Operation
Scanner Preparation
Operating the Remote Controller
This remote controller also operates as a digital-scanning
bar code reader.
Press SCANNER ON/OFF to turn it on.
If the remote controller is not operated within 60 seconds
(within 4 minutes when setting the clock time), the lamp and
Display turns off.
When the lamp is not lit, press SCANNER ON/OFF to turn it
on again.
When the Bar Codes Cannot be Read
Although the lamp in the tip of the Bar Code Reading
Section lights up;
•No figures appear in the Display
•No beep sounds is heard:
The tip of the Bar Code Reading Section is probably
clogged with dirt.
Scanning
adaptor
Bar code
0
Lamp
#
Reading the bar codes
4 Fit the remote controller to the scanning
* adaptor._________________________________
O
Trace the bar code quickly in the
^ direction of the arrow, ensuring that you
trace it completely past the last bar.
•The “Bleep" sound indicates that the bar code has
been read completely.
Cleaning
H Remove the cap of the Bar Code
■ Reading Section.
• Remove dirt and dust from the hole of the cap.
O Gently wipe the tip of the lamp with a
^ soft cloth.
• Reattach the cap by inserting it until it locks with a
click.
0
Ю