Assemble the camera, A. sideway cable exit – Panasonic WV-BS504 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PAL(CCIR)orNTSC
(EIA)
01РФ
OFF
NTSC (EIA)
ON
PAL (CCIR)
Note: The dip switch P is not for changing NTSC
(EtA) to PAL (CCIR) or PAL (CCIR) to NTSC
(EIA). This switch is set at factory. Do not
change the setting of this switch. The factory
setting is OFF.
procedure. Take
3. Assemble the camera
Reverse the disassembly
care not to cut any cables.
Precautions:
1. The following installation work should be
referred to qualified service personnel or
system installers and must conform with local
codes.
2. Be sure to select a ceiling board that is strong
enough to support this camera.
a. Sideway cable exit
Prepare a cutout in the diecast case and
decoration cover as shown in the following
drawing.
Note: Be sure to protect the video and power
cables. Otherwise, the cut edges will
damage the cables.
1. Remove the mounting screw (M3) from the
camera mounting angle (provided).
2. Mark the mounting holes on the ceiling, using
the removed camera mounting angle as a
template.
Fix the camera mounting angle to the ceiling
with four screws (not provided).
Caution:
The installation should be strong enough
to support 4 times the total weight.
- 3 0 -