Unit number, Baud rate, Data bit – Panasonic WV-BS504 User Manual
Page 13: Parity check, Stop bit, X on/x off, Wait time, Alarm data, Auto 1, Auto 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UNIT NUMBER
Specifies the camera
ID
numbers in case more than two cameras and WV-RM70 controllers are daisy chain
connected. Select (1-32), (33-64) or (65-96) with the dip switch. The factory setting is 1.
BAUD RATE
Specifies the transmission speed (2400, 4800, 9600, 19200 bps). The factory setting is 19200,
DATA BIT
Specifies the number of data bits (7 or 8 bits). The factory setting is 8.
PARITY CHECK
Specifies the parity (NONE, ODD, EVEN).The factory setting is NONE.
STOP BIT
Specifies the number of stop bits (1 or 2 bits). The factory setting is 1.
X ON/X OFF
Specifies whether to apply flow control or not (NOT USE, USE). The factory setting is NOT USE.
WAIT TIME
Specifies the time to wait until retransmitting after confirming that no data is received from the controller.
(OFF: no transmission, 100, 200, 400, 1000 ms),
ALARM DATA
Specifies the alarm data transmission mode (POLLING, AUTO 1, AUTO 2). The factory setting is AUTO 2.
POLLING:
Transmit the alarm data to the controller against request from the controller.
AUTO 1:
Transmit the alarm data each time the alarm signal is received.
AUTO 2:
Transmit the alarm data every five seconds. (This mode is recommended when WV-CU550A is used).
Note:
When POLLING is selected, the alarm data is not transmitted automatically by using WV-CU550A.
DELAY TIME
Specifies the time to transmit the acknowledge request when communicating on a two-line connection.
(OFF, 10, 20, 40, 100 ms) The factory setting is OFF.
This menu appears only when a two-line communication is used.
The settings become effective with closing of the SET UP MENU.
Note:
If
the
condi:ions
of
the
communication
for
the
camera
became
effective,
the
communication
between
the
camera and the controller may not work. Set the conditions of the communication for the controller to the
same as the camera's. The communication between the camera and the controller works correctly.
Setting the dip switch C inside the camera unit to ON resets the conditions of the communication for the
camera to the factory preset settings. (See page 29)
The following communication parameters can be set:
- 11