Shutter speed (shutter), Gain control (agc), Electronic sensitivity enhancement (sens up) – Panasonic WV-BS504 User Manual
Page 10: Notes, Synchronization (sync), Important notice, Note, 7) white baiance (white bal)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Note;
The result of field setup of the mask area and level adjustment is fed back (effected) to the lens iris
control in ALC mode.
(3) Shutter Speed (SHUTTER)
You
can
select
the
shutter
speed
from
1/60
(OFF),
1/10000 second.
Note:
See page 21 for the setting.
1/120, 1/250, 1/500, 1/1000, 1/2000. 1/4000, and
(4)
(5)
(
6
)
Gain Control (AGC)
You
can
set
the
gain
{brightness
level
portion
of
an
image)
to
automatic
adjustment
(Automatic
Gain
Control ON) or fixed (Automatic Gain Control OFF).
Note;
See page 22 for the setting.
Electronic Sensitivity Enhancement (SENS UP)
The
electronic
sensitivity
emhancement
(SENS
UP)
function
varies
the
shutter'speed
to
raise
the
sensitivity
in low light conditions when OFF is selected for ALC,
You can select the shutter speed for SENS UP from the preset values as follows;
1/30 seconds (x2), 1/15 seconds (x4), 1/10 seconds (x6), 1/6 seconds (xIO), 1/3,8 seconds (x16), or 1/1,9
seconds (x32).
There are two modes for SENS UP as follows;
AUTO: If you select x32, for example, the sensitivity is raised automatically to x32 max.
FIX: If you select x32, for example, the sensitivity is raised to just x32.
Notes:
• See page 22 for the setting.
• Moving objects will appear blurred when shot during the electronic sensitivity enhancement mode
since SENS UP is equivalent to setting the shutter speed to a slower speed in a still picture camera.
• The horizontal and vertical resolution will be lowered in this mode.
• If the video output level is adjusted too low (the iris opening is too small), the Electronic Sensitivity
Enhancement (SENS UP)/AUTO mode will not function. Select ALC PRESET ON in this condition.
Synchronization (SYNC)
You can select internal sync mode (INT) or line-lock sync (LL). Additionally, this model accepts the VD2
signal
(multiplexed
vertical
drive
signal)
with
the
composite
video
output
signal
from
a
specified
component. Whenever the VD2 signal is supplied to this camera, the camera automatically switches to the
VD2 sync mode.
When you select line-lock sync (LL), you can set vertical phase adjustment for composite sync mode or
horizontal and sub-carrier phase adjustments for the black burst mode.
Important Notice:
The priority of sync modes is as follows:
1. Multiplexed Vertical Drive (VD2) (Highest)
2. Line-lock (LL)
3. Internal Sync (INT) (Lowest)
Note:
The priority of automatic sync mode is the same as shown above. See page 22 for the setting.
(7) White Baiance (WHITE BAL)
(available only with WV-CS604A, WV-CSR604, or WV-CST604)
You can select one of two modes for white balance adjustment as follows:
- 8 -