Panasonic WV-BS504 - Manual (Page 29)

2. To set an area
Move the cursor to MANUAL or AUTO, and press the CAM (SET) key.
The AF AREA SET menu is shown. Move the cursor to AREA, and
move the joystick to the left or right to select LARGE, MID or SMALL
for the area.
3. To confirm operation
To check auto focus operation, move the cursor to AF CHECK, and
press the CAM (SET) key.
Notes:
• When the electronic sensitivity enhancement (SENS UP) is active, this
function is automatically set to MANUAL.
• The auto focus lens may not function properly in AUTO under the
following conditions.
1. Dirt or water on window glass.
The auto focus may focus on the dirt or water.
2. Low lighting/illumination or zone marker is blinking.
3. Bright objects or high intensity objects.
4. Single color with unfigured object such as white wall or fine felt.
5. No center objects, sloping objects.
6. Far and near objects on the screen.
Area setting menu
12. Special Menu (SPECIAL)
This menu lets you adjust and set up the video signal of the camera to
meet your requirements.
• Display SET UP on the monitor screen.
(Refer to Setup Menu Display on page 10 for details on displaying
the SET UP on the monitor screen.)
• Move the cursor to SPECIAL and press the F2 button of the WV-
CU550A. The special menu appears on the monitor screen.
(For the WV-RM70, keep pressing the Right and Left switches
simultaneously for more than 2 seconds.)
Camera setting menu
/ ---------------------------------
** SET UP **
CAMERA ID OFF *
ALC/MANUAL ALC *
SHUTTER OFF
AGC OH
SENS UP OFF
SYNC INT
WHITE BAL ATW *
WIDE D-RANGE OFF
MOTION DET OH
AF MODE MANUAL *
BET 1 SPECIAL _U
\_____________________ -J
(1) Chroma Level Setting (CHROMA GAIN)
(available only with WV-CS604A, WV-CSR604, or WV-CST604)
1. Move the cursor to CHROMA GAIN. The "I" cursor starts blinking,
2, While observing the vectorscope or color video monitor, adjust the
chroma level by using the joystick. The “1" cursor moves to the left or
right.
To reset to the factory setup, press the F2 button of the WV-CU550A.
(For the WV-RM70, keep pressing the Right and Left switches
simultaneously for more than 2 seconds.)
(2) Aperture Level Setting (AP GAIN)
1. Move the cursor to AP GAIN. The 1" cursor starts blinking,
2. While observing the video monitor, adjust the aperture level with the
joystick. The “I" cursor moves to the left (soft) or right (sharp).
To reset to the factory setup, press the F2 button of the WV-CU550A.
(For the WV-RM70, keep pressing the Right and Left switches
simultaneously for more than 2 seconds.)
Special menu
** SPECIAL **
CHROMA GAIN . . . . . .
AP GAIN
_____ I_______
PEDESTAL .1...................
HUE . . . . 1 . . . .
DP SIDE DOWN OFF
REFRESH
-»PUSH SH
CAMERA RESET -»PUSH SW
— ------- \
** SPECIAL **
CHROMA GAIN . . . . 1 .
AP GAIN --------IV
PEDESTAL . 1 . . . .
H U E . . . . 1 .
UP SIDE DOWN OFF
REFRESH -»PUSH SW
CAMERA RESET -»PUSH SW
RET
-J
-27 -