Panasonic WV-BS504 - Manual (Page 12)

■ Menu Display
• Setup Menu Display
1. Select the number of the camera you want to set up and a monitor to
display the SET UP MENU.
2. Display the D4 menu on the LCD by pressing the appropriate cursor
buttons.
3. Press the FI button.
The SET UP MENU appears on the monitor.
4. To close the SET UP MENU, press the F4 button.
Note:
Do not change the SET UP MENU (for camera communication)
settings of the WV-CSR604 except CAMERA*. If those settings
are changed, the camera and the controller may get out of
control,
• Submenu Display
The items marked * can be selected/changed on the submenu.
• Move the cursor to an item with the * mark and press the CAM (SET)
key. The submenu is displayed.
Note:
When you use the WV-CSR604, move the cursor to CAMERA on
the
SET UP MENU for camera communication and press the
CAM (SET) key. The SET UP MENU for camera setting appears
in the display.
D4 menu
[
[
Camera Set Up Menu
On Exit
IF.II F2 F3 F4
Camera Set Up Menu
Res A.Res Exit
FI F2 F3 IP:41
1
I
Setup menu
for camera communication
(only for WV-CSR604)
**» SET UP MEHU
I CAMERA *~l
UNIT HUMBER
BAUD RATE
ПАТА BIT
PARITY BIT
XOH/XOFF
WAIT TIME
ALARM DATA
DELAY TIME
1
19200
e
NONE
NOT USE
OFF
А1ГГО 2
OFF
COM. SET UP DISABLE
Setup menu
(for camera setting)
/-------------------------------------------
--------
\
*** SET UP MEHU •••
PRESET[i;2
MAP*
HOME POSITION
15
SELF RETURN lOMIN
AUTO MODE OFF
LOCAL/REMOTE LOCAL
CAMERA *
Ч____________^______________ __________/
■ Communication Parameter Setting
e Initial camera communication parameters
• Confirm the communication parameters of the matrix switcher (WJ-SX550A), and display the camera SET
UP MENU.
The initial camera communication parameters are shown in illustration above.
The other parameters are as follows:
Daisy : OFF
Camera In Number: 1
F/H Duplex : Full
■ Changing the camera communication parameters
1. Display the SET UP MENU, Move the cursor to COM. SET UP DISABLE and press the CAM (SET) key to
select COM. SET UP ENABLE.
2. Move the cursor to the item and select the parameter by moving the joystick to the left or right.
- 1 0 -