Panasonic AG7150 - Manual (Page 21)

Sensor Recording
(
ag
-
tsso
only)
Model AG-7150 is not equipped with recording function.
The unit allows to start recording automatically if a video input signal is supplied to the unit from an external source such as a
satellite, etc.
1
.
Turn on the unit and insert a
video cassette.
Make sure that the erasure prevention tab on the video cas­
sette is intact.
2. Set the SENSOR REC Selector.
In case of "VIDEO” setting:
■ The “SENSOR” indicator will appear on the tape counter and
the unit will be set to the standby mode. When a video signal
is inputted into the VIDEO IN Connector, the unit is turned
on and set to the recording mode. When there is no more
signal, the unit will go into the stop mode and, after a while,
be set to the standby mode again.
w
o
Q.
o
O)
c
In case of “REMOTE” setting:
■ The “SENSOR" indicator will appear on the tape counter and
the unit will be set to the standby mode. When a recording
start signal is inputted into the SENSOR REMOTE Connec­
tor on the rear panel, the unit is turned on and set to the
recording mode. When a recording end signal is inputted,
the unit will go into the stop mode and, after a while, be set
to the standby mode again.
■ The tape position where the SENSOR recording started also
becomes the beginning position of the REPEAT playback.
Simi tarty, the tape position where the recording ended be­
comes the end position of the REPEAT playback, and the
repeat mode is automatically set to “REPEAT CONTINUE”.
o
u
CE
VIDEO I
SEMSOR REC
Notes
The "SENSOR” indicator will blink if no video cassette or a video cassette with its erasure prevention tab broken off
is inserted in the unit after the SENSOR REC Selector is set “VIDEO” or “REMOTE".
When the tape reaches its end during the SENSOR recording, the unit is set to the stop mode and turned off.
Any operation buttons are inoperative after the SENSOR REC Selector is set.
21