Panasonic DMR-T3030 - Manual (Page 51)

Changing the unit’s settings
Common procedures
See page 52 for menu and option details.
1
Press [SETUP] to show the menus.
Antenna System
Auto Channel Setting |
ChannelXapiton
Preset Channel Caption
Manual Channel Caption |
j VCR Plus+CH Setting
^ OGSiESD
Tabs Menus Options
2
3
4
Press [▲, T ] to select the menu’s tab
and press [^].
Press [ A , T ] to select the menu and
press [ENTER].
Press [ A , T ] to select the option and
press [ENTER].
The screen now shows the menu again. •
• Some items require different operations. Read the following expla­
nations.
To return to the previous screen
Press [RETURN].
When you are finished
Press [SETUP].
Entering a password (Ratings)
The password screen is shown when you select levels 0 to 7.
1. Input a 4-digit password with the numbered buttons.
• If you enter a wrong number, press [CANCEL] to erase it.
2. Press [ENTER].
•The lock symbol appears closed to show the rating is locked.
• Do not forget your password.
3. Press [ENTER] to confirm the 4 digits.
Now, when you insert a DVD-Video that exceeds the ratings limit
you set, a message appears on the television.
Follow the on-screen instructions.
Digital Audio Output
Change the settings when you have connected equipment through
this unit’s DIGITAL AUDIO OUT terminal (-^page 47, Q).
Select the “Audio” tab and then “Digital Audio Output” by fol­
lowing “Common procedures” (-♦ left) to set up “PCM Down
Conversion”, “Dolby Digital” and “DTS”.
PCM Down Conversion
Select how to output audio with a sampling frequency of 96 kHz.
Select “On” if the equipment you connect cannot process signals
with a sampling frequency of 96 kHz.
• Select “Off” if you use analog connect irrespective of the type of
equipment.
Off (Factory preset):
Output as 96 kHz. There is no output if the disc has copy protection.
Select “On” in this case.
On:
Converted to 48 kHz for output.
Dolby Digital and DTS
Bitstream (Factory preset for Dolby Digital):
Select if the equipment you connected can decode the signal.
PCM:
Select if the equipment you connected cannot decode Dolby Digital
signal.
Off (Factory preset for DTS):
Select if the equipment you connected cannot decode DTS signal.
IMPORTANT
If the equipment you connected cannot decode the signal, the
setting must be changed to PCM or Off. If not, signals the
equipment cannot process will be output by this unit, causing
high levels of noise which can damage your hearing and the
speakers.
■
2
0)
&
■D
0)
u
c
2
■o
RQT6636