Panasonic DMR-T3030 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

The program is erased.
Press [◄] to
select “Erase” and
press [ENTER].
una
• The disc’s available recording time may not increase after
erasing short programs.
• Computer data cannot be erased.
• The available recording time on DVD-R does not increase when
you erase programs.
The program list reappears.
• You cannot enter titles if the disc is protected,
iimjj
• The full title is shown in the Properties screen, but if you
enter a long title, only part of it is shown in the program list.
• If you enter a long title, only part of it is shown in the menu screen after
finali
2
ation.
Press [-^1 to set (or
cancel) protection
and press [ENTER].
The lock symbol
appears when the
program is write-
protected.
□sQOisoeiaEilusj:
ir...ni—ir
TOTALS
Hi
micr.
■
O)
c
g
Press [ENTER] at
the start point of
the section you
want to erase.
Press [ A , ▼] to select “Next” and press [ENTER], then press
[◄] to select “Erase” and press [ENTER].
Repeat to enter other sections.
Press [ A , T ] to
select “Exit” and
press [ENTER].
• Use search and slow-motion to find the start and end points.
• Play pauses when the end of the program is reached during this procedure.
• You may not be able to specify points within 3 seconds of each other,
• You cannot specify an end point before a start point.
• You cannot specify points if you have recorded still pictures on other equipment.
• The disc’s available recording time may not increase after erasing short segments.
Sfewt RMumisg HMsnllag nni [ t í a ÎPI C№itt(oiUlnii tlAÏ LIST Hill )ln bi tmti. c -feg- Press [◄] to select “Erase” and press [ENTER]. Press [ENTER] at the point you want to divide the program. Press [ A , T ] to and press [ENTER]. Dnca iniu divida ttia progran, The program is divided. I Divida ~l J latel [ Press [^] to select [ENTER]. ' By selecting “Preview” and pressing [ENTER], play will begin from a point 10 seconds prior to the division point. You may wish to make sure that the division point is at an appropriate location. If it is not necessary to change the division point, select “Exif and • Use search and slow-motion to find the points. -When the resulting part(s) are extremely short. -When the total number of programs is more than 99.
select “Exit”
It nUl isl ba raitofad ta Iht ailgtajl.
“Divide” and press
press [ENTER], To change the division point, press [RETURN], select “Divide Program” and redo from the start.
• It is not possible to carry out Divide Program in the following cases: