Changing the remote control code – Panasonic DMR-T3030 User Manual
Page 50
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Changing the remote control code
1
.
C
P
■C
г
(U
a
о
"D
Q)
U
c
g
p
2.3-Ф5
2.3-Ф5
I
□
c=3
о о о (Щ)
I
................... .
FUNCTIONS RETURN
Most of the DVD recorders and players manufactured by Panasonic
use the same remote control system. If you have more than one
piece of equipment placed in proximity to each other, they may all
respond to the signal. If this occurs, you will have to alter the code
on the unit as well as on the remote control {the two must match)
using the following procedure.
• Use “t", the factory set code, under normal circumstances.
1
Press [SETUP] to show the menus.
ешш?
Channel
МЩ1Г
№Sp.lay,
Antenna System
Ante Channel Setting
CtianneLCaptlon
Preset Channel Caption
Manual Channel Caption ^
VCR PI11S+CH Setting |
f
cat
2
Press
[ A , T ] to select “Set Up” and
press [►].
3
Press
[ A , T ] to select “Remote Con
trol Code” and press [ENTER].
4
Press
[ A , T ] to select the code (1, 2,
or 3) and press [ENTER].
The remote control code on the unit has been set.
5
While pressing [ENTER] on the
remote control, press the numbered
button ([1], [2] or [3]) corresponding
to the code you selected in step 4.
The remote control code on the remote control has been set.
6
Press [SETUP]
If the unit doesn’t respond, you have entered the wrong code.
Repeat step 5 to enter the correct code.
идя
• The following display appears on the unit’s display if its code and
the remote control’s code are different. Change the remote con
trol’s code to suit the unit. The display disappears after about 5
seconds.
The unit’s remote control code
• You can also set the main unit’s code without using the remote
control.
© Press [FUNCTIONS] on the main unit.
@ Press [▲, ▼, ◄, ►] to select “SETUP” and press [ENTER].
@ Carry out procedure 2-4 above.
@ Press [RETURN],
RQT6636