Panasonic WJ-PC10 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

3. System Data Transmitting Indicator

(SYS DATA TX)
This indicator blinks irregularly for both PC-mode

and

Extension-mode

while

this

unit

sends

the

system data out.

Note:

When the system data error occurs, this LED

blinks in 0.5 sec. interval. See page 18 for

details.

4. RS-232C Receiving Indicator (RS-232 RX)

This indicator blinks irregularly for both PC-mode

and

Extension-mode

while

this

unit

receives

RS-232C signal from another unit such as Modem

or computer.

Note:

When the system data error occurs, this LED

blinks in 0,5 sec, interval. See page 10 for

details.

Note:

When the system data error occurs, this LED

blinks in 0,5 sec, interval or the error is

indicated on the monitor TV, See page 10 for

details,

6. RS-232C Connector (RS-232C)

Connect this connector with Modem unit, computer

and so on.

Pin configuration

1. GND (Frame ground)

2. SD (TXD)

3. RD (RXD)

4. RS(RTS)

5. CS (CTS)

6. DR (DSR)

7. SG (Signal ground)

20. ER(DTR)

Other pins are not used.

5. RS-232C Transmitting Indicator (RS-232 TX)

This indicator blinks irregularly for both PC-mode

and

Extension-mode

while

this

unit

transmits

RS-232C signal to another unit such as Modem

or computer.

7. Controller Number Selection Switch

. (CONTROLLER UNIT NO.)

This

switch

used

identify

the

Controller

Unit Number in the system.

Up to five(5)

WV-CU300/WJ-PC10

can

installed

the

system.