Panasonic WJ-PC10 - Manual (Page 10)

1. SW3 ; Selection of the baud rate of RS-232C signal,
Turn on one of 6 switches.
No.1 1200 bps
No.2 2400 bps
No.3 4800 bps
No.4 9600 bps (Factory set up)
No.5 19200 bps
No.6 38400 bps
SW4 : Selection of the function.
The factory preset switch position is OFF for all
switches.
Select ON or OFF position according to your system.
2-1. Operation mode : PC-mode
SW No. Function Switch position
No.1 Parity bit ON:None OFF:Yes
No.2 Parity mode ON:EVEN OFFODD
No-3 Stop bit ON:2bit OFF:1 bit
No,4 Data bit ON:8bit OFF;7bit
No.5 Alarm selection ON:stop OFF:release
No.6 Main/Sub selection Should be OFF position
No.7 DTE/DCE selection ON:DTE OFFiDCE
No.0 Operation mode Should be OFF position
Note:
When the Alarm switch (No.5) is turned on,
the alarm signal to the RS-232C line can
be stopped. However, the alarm signal
can be confirmed by operating computer via
WJ-PC10.
2-2. Operation mode : Extension-mode
Function
Parity bit
Parity mode
Stop bit
Data bit
Xon/Xoif control
Main/Sub selection
DTE/DCE selection
Operation mode
Switch position
Should be OFF position
Should be OFF position
Should be OFF position
Should be OFF position
Should be OFF position
ON:Sub OFF:Main
ON:DTE OFF:DCE
Should be ON position
Note on Extension-mode:The Modem units should
be set as follows.
Parity
Stop bit
Data bit
Xon/Xotf
None
1 bit
8 bits
Not used
- 8