Panasonic WJ-PC10 - Manual (Page 14)

The maximum time delay between the Main
WJ-PC10 and Sub WJ-PC10 should be less than
O.lsec. If the time delay is more than O.lsec, the
WJ-SQ508 on the Sub WJ-PC10 wilt not operate
correctly.
Sub Main
Time delay less than 0.1 sec
Important:
1. Refer to the Operating Instructions of the System
300 products for the connection and setting up of
the system.
2. When the Modem is connected with the telephone
line, the Modem should be set to the "exclusive
line mode" due to WJ-PC10 does not have dialing
function,
3. The recommended baud rate of the RS-232C signal
is more than 9600 bps if quick response is required
such as the pan/tilt or focus/zoom of the lens
operatioa
1. PC-mode system
In this application, the System 300 can be remotely
controlled or operated by the computer through
WJ-PC10. The another system may connect with
the computer,
important:
The communication software should be
necessary to operate your system. Please
contact with your dealer or system installer.
SYSTEM APPLICATION
- 1 2 -