Panasonic OMNIVISION PV-V4611 - Manual (Page 9)

'Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
5 Press CHA Key to start Channel/Clock
Auto Set operation. Settings are
performed automatically. If the setup is
completed, the following screen is
displayed.
VCH r&LOCKI &HANNEL
[171372001 SUM 2:20PU
DST:ON
SETTJNG : CH 10
If “Auto Clock Set is Incomplete"
screen appears, set the clock using
MANUAL CLOCK SET procedure
shown below.
Pvcn I CLOCK I CHANNEL
ALTTO CLOCK SET IS
INCOMPLETE
POWER
VCR
VCR/TV
SELECT/
SET
A :PLAY
T :STOP
◄ ;REW
► :FF
ACTION
CH A/V
Manual Clock Set
If Auto Clock Set was incomplete, manually
set the clock as follows.
1 Press ACTION Key on the Remote to
display CLOCK Menu screen.
rv'cn I CLOCKl CHANNEn
2
SELECT MONTH
SELECT:* T SET:
LeXIT : ACT I ON
Press A T to select the month and ►
to set. In the same manner, select and
set the date, year, time, and DST
(daylight saving time).
3
rvCH I CLOCK I CHANNETj
11/11/2001 SUN 12:00PM
OST:ON
SET COMPLETED
SET ►
START : ACT I ON
Press ACTION Key twice to start
CLOCK and exit.
Reset All VCR Memory Functions
Use when moving VCR to new
location, or if a mistake was made in
the Initial Setup section.
• Make sure a tape is not inserted in
the VCR.
Press and hold both
PLAY and CHANNEL
A
on the VCR for
more than 5 seconds.
• The power shuts off.
Do “Initial Setup” on page 8.