Panasonic OMNIVISION PV-V4611 - Manual (Page 19)

‘Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
VCR Plus+ Programming
[^^Ready Check List
□ Clock is set.
Q VCR Plus+ Setup is complete (see page 18).
1
r№fl>Kjs+ r^oa I LIST'
DATE START STOP CM
13 SAT-:-
TODAY
SELECT:* T ^ ►
EXIT : PRCX3
Press PROG/VCR+
to display PROGRAM,
LISTl
ENTER PLUSCODE NUMBER
USING 0-0 KEYS
SELECT: * V .4 ••
£iill______ :PROG
Press A >■
to select display VCR
Plus-p screen.
'VCRPUiTI 'PRO^ LIST1
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
BACKSPACE :
4
TPflOG
' If the Pluscode
number entered
begins with “0,” skip
to step 5. Display in
step 4 will not appear.
Press number keys
to enter PlusCode
number.
To Make Corrections,
press < repeatedly
to delete number, then
repeat step 3.
press PROGA/CR+ to
set.
DAILY(MON-FRI)
WEEKLY
SELECT :*T SET:^
END :PROG_________________
Press AT
to select ONCE,
DAILY(MON~FRI), or
WEEKLY record
frequency and press ►
to set.
I VCR PhiSt I PF
DATE START'
nsTi
’ cil
13 SAT 2:20P 3:20P 02
TODAY \ I )
— SLPt-
SELECT record SPEED /|\
SELECT:* * SET: < ►
END :PROG
Press AV
to change record speed
and press ► to set.
Press PROG/VCR+
to end program.
VCR Plus* I PROG.
IP DT START STOP
CANCEL :A0D/D1
SELECT :* Y
EXIT : PROG
Press PROG/VCR+ again
to exit.
* Press ADD/DLT
to delete the program.
Press POWER off to set timer.
(TIMER” lights on Multi Function Display.)
POWER
SELECT/
SET
A:PLAY
▼ :STOP
◄ :REW
► :FF
PROG/
VCR-H
NUMBER
keys
ACTION
ADD/
DELETE
Do normal Timer Record if...
• PlusCode number is not listed for
program.
• program (e.g. sports event) may run
over set stop time.
See page 17 to:
• cancel a timer recording in progress.
• review, replace, or clear program
contents.
Important for DSS/Cable Box Users
• When recording via DSS, the receiver
must be left on. When recording via
cable or antenna, DSS receiver must
be off.
• When recording via a cable box,
leave box on and tuned to channel 1o
be recorded.
Do not overlap program times.
VCR PlusCode numbers cannot be
used to program VCR to record DSS
and cable box channels.
Make each entry within 1 minute or the
VCR will exit setup mode.
Once VCR Plus-p channel setup is
done, channels stay in memory. If a
power interruption occurs, VCR Plus+
channel setup may be lost. Please do
VCR Plus+ channel setup again.
Obtain unlisted PlusCode numbers by
calling 1 - 900 - 454 - 7587. Call costs
about $.95 per minute.
19