Panasonic OMNIVISION PV-V4611 - Manual (Page 17)

'Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
Review, Replace or Clear Program Contents:
(Recording is not in progress)
1
VCR Pk«+ 1 PROG. _> list “1
P DT START STOP CH SPD
1 7 9:00A12:00A 08 SP
2 8 10:OOP12:OOP 02 SP
3 to 0: OOP 9: OOP 10 SP
4 SU fl: OOP 10: OOP LI LP
▼
SELECT:A T 4 p
EXIT : PROG
1) Press
PROG/VCR+.
2) Press
to select LIST.
VCR Plua* I PflOG.
QT START STOP CM SPO
8 10:00P12:00P
e:OOP 9:00P
SU 9;00M0;00(‘
SP
10 SP
LI LP
CANCEL :ADD/DLT
SELECT : a t SET:P
EXIT iPROG
Press AW
to select number.
To cancel a Timer
Recording in progress...
Press POWER and then STOP
within 10 seconds to cancel the
Timer recording. (The TIMER
indicator goes out on Multi
Function Display.)
To Replace program...
7 m 9-.OOA 12-.OOA Ofl
TODAY
SELECT ia T SET:^ ►
END____ : PROG
1) Press ►
to display.
2
)
Repeat Step 3
(pg.16) to set
new programs.
or
To Clear program...
VCR Pfaat I PROG.
p dt start stop
2 8 10: OOP 12: OOP
3 10 8:00P 9:OOP
I SU 9: OOP 10: OOP
CANCEL l ADD/DLT
select : a t set ; ►
EXIT : PROG
Press ADD/DLT.
Press PROG/VCR+
to end the program.
• If there are set programs, press
POWER off to set timer.
SELECT/
SET
A :PLAY
T :STOP
◄ :REW
► :FF
PROG/
VCR+
ADD/
DELETE
- Important notes when using a DSS receiver —
When recording programs via a DSS receiver, the DSS
receiver must be left on.
When recording programs via an antenna or cable, the DSS
receiver must be turned off.
17