Panasonic OMNIVISION PV-V4611 - Manual (Page 8)

Initial Setup for Aisn/Cable - VCR -TV Connection
How to Connect
(D
2
Connect the Cable from Antenna/Cable to the IN FROM ANT.
terminal on VCR.
Connect the OUT TO TV terminal on the rear of VCR to the ANT.
IN terminal on TV using the RF Cabie (included accessory).
How to do Initial Setup
1
2
Press VCR* for VCR mode. Turn
the TV on and set it to channel 3.
Turn VCR on.
When VCR is turned on the first
time, SELECT LANGUAGE screen
appears.
3
Press CHA to select English,
or
Press CHV to select Spanish,
or
Press VCR/TV key to seiect French.
When one of above keys is pressed,
SELECT CONNECTiON screen is
dispiayed in the selected language.
If screen does not appear, check
connection between VCR and TV
and, if TV is tuned to channel 3, try
switching it to channel 4.
When you want to change the output
channel of VCR, please refer to VCR’s
Output Channel on page 13.
If wrong language is set, do “Reset All
VCR Mennory Functions” steps on
page 9.
4
n^R I CLOCK I CHANNEL
CABLE/DSS BOX^VCR^TV
VCR»-CABLE/(JSS BOX»TV
SELECT:* r
EXIT : ACT I ON
Press A ▼ to select connection
and press ► to set.
CHANNEL7CLOCK AUTO SET
screen appears.
r WARNING--------------------------------------------------------------------
When using "Nut type" RF coaxial cables, tighten with fingers
only. Overtightening may damage terminals.
rvCR I CLOCK I CHANNETI
WEL/CUKK AUTO SET
CONNECT ANTENNA CAGLE
AND IF YOU USE A CABLE
BOX, TUNE IT TO YOUR
LOCAL PBS CH THEN. . ,
PLEASE PRESS CH UP KEY
8
For assistance, please call ; 1-800-211-PANA{7262) or send e-mail to : [email protected]