Panasonic OMNIVISION PV-V4611 - Manual (Page 18)

Timer Recording Using VCR Plus+® System
VCR Plus+ System is ...
a feature that allows you to set most items of a timer recording by simply entering a special code
number (PlusCode programming number) found in TV GUIDE and selected newspaper TV
listings.
Initial Setup...
In order to use Timer Programming Using VCR Plus+, the Initial Setup on page 8 to 11 must be
completed for setting Clock and Channel.
Channel Setup.....
Since Plus Code numbers assigned to channels (found in TV Guide and selected newspapers)
may differ from channels in your viewing area, you’ll need to enter your local TV channel number
for each corresponding Guide Channel.
If you perform the VCR+ Channel set up procedures shown below, you will be able to perform timer
recordings using the VCR+ code-programming number listed in your local TV listing.
To complete step 4 of setup, do the
following:
■ Prepare a TV/Cable station line-up and
channels they are received on. Also, the
Guide (PlusCode) numbers assigned to
your stations (found in TV Guide and
selected newspapers.)
• Make a 3-column chart (see sample).
Left column -> all stations you receive.
Middle column -> each station’s
assigned Guide (PlusCode) number from
TV Guide, etc.
Right column -> channel number on
which your TV receives the station.
VCR Plus+ Channel Setup
For [VCR-TV] or [VCR-cable box-TV] connection only.
SAMPLE ONLY
Broadcast or Cable
station name
Assigned Guide
(PlusCode)
channel No.
Channel No. on
which my TV
receives the station.
HBO 33-^ 15\
Nickelodeon 38
к CBS 04 04^
X.FOX 11
VCR Plus-t- and PlusCode are
registered trademarks of Gemstar
Development Corporation. The VCR
Plus-
1
- system is manufactured under
license from Gemstar
l^Development Corporation._________
1
HjOCkT_ CHANNST
REPEAT PLAY OFF '
REMOTE WARNING :ON
AUTO SHUT-OFF :ON
lOtOlWtLANGUE : ENGLISH
VCR’S OUTPUT CH :3
Press ACTION*
to display menu.
rVcn~ I CLOCK [►CHANNEL
ant E nnla ’T^ dle
AUTO SET
WEAK SIGNAL DISPLAY : OFF
CABLDDSS BOX SET UP
VCR Plu*+ CH SFT UP
Press < ►
to select CHANNEL.
ГУСЯ I CLOCK [" channel I
ГАГПЁМКЛ : CABLE I Press
JkW
1 Г.АВ 1 ГАУ№ вок RFT UP I tO SSleCt VCR PIUS +
CHANNEL SETUP,
and press ► to set.
To enter VCR Plus+
channels,
press ► to move cursor
to right, press AT to
enter number, press 4
to set, and press at to
scroll up/down.
• Repeat step 4 until
list is complete.
To Make Corrections,
press AT and ► to move to error, then at to
change, or ADD/DLT to erase number.
Press ACTION twice
to end setup.
CLEAR I ADD/DLT
SELECT t A T SET: 4
EXIT___ ^ACTION-_______ __
18
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]