Panasonic SCAK50 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the play Hmar^j
Press ©PLAY/OREC to select “0PLAY”.
Every time you press the button;
©REC — ©PLAY
---- Out (OFF) -•-----
c
J
Power will shut OFF automatically in a few seconds.
The timer play will start at the preset time with volume
increasing gradually up to the volume level you preset.
To switch the timer OFF: Q
Press ©PLAY/OREC and check "©PLAY" goes out.
If you set the timer wrongly Q
Press ©PLAY/OREC so that "©PLAY" goes out. Then, repeat the
procedure from step 1.
To check settings
Press CLOCK/TIMER to select "©PLAY". □
Two seconds later, the display will change in the following order.
® Play start time
(2) Play end time
(3)
Play source and playback volume
You can check settings even when power is OFF.
To enjoy the desired source after the timer setting is completed
Even if you change the volume level or music source, the timer play
will start with the preset condition.
1. Following step 6, turn ON the power and start playing the desired
source.
When you select a CD as the program source
After the CD finishes, if more than 2 CDs are loaded in the player,
reset the programmed CD with DISC 1 - DISC 5, and press ■.
2. Press POWER to standby mode after enjoying the play, and confirm
CD(s) or tape(s) has (have) been inserted.
Turning the timer ON/OFF
As long as "©PLAY" is displayed, the play timer will come ON
everyday as set.
You can turn the timer ON/OFF by pressing ©PLAY/OREC while
power is OFF.
Remember that when "©PLAY" is displayed, the timer is ON. When
not displayed, the timer is OFF,
• If the power is on, the timer will not function. The system must be
in the standby mode.
• If you switch the power to the standby mode while the play timer
is functioning, the OFF time setting will not be activated.
• If AUX is selected as the source, when the timer comes ON, the
system will turn ON and will engage "AUX" as the source. If you
want playback from the connected component to start, set the
component's timer to the same time. (See the instruction manual
that came with the component.)