Panasonic SCAK50 - Manual (Page 21)

Itecoixff ng from comfmcf
Press DECK 2 ± OPEN, and then insert the tape.
CEose the holder by hand.
Tape direction is automatically set to
Press DOLBY NR.
You have to turn Dolby NR ON/OFF according to the tvpe oi
recording you want to make.
Every time you press the button; qq (OFF)
Press REV MODE to select the reverse mode.
Every time you press the button;
z -
cr>
1
c
1
* : One side is recorded, then recording stops auto­
matically,
: Both sides (front side * * reverse side) are recorded,
then recording stops automatically.
Press CD.
Load CDs into each of the trays.
(See page 20).
Press DISC 1 - DISC 5 whichever disc you want.
Pressing ■ will stop playback.
Press • REC/STOP to start recording.
• If you selected in step 3, the direction will automatically
change to when recording starts,
• The recording will proceed from the first track on the selected
CD and will continue on through the last track of the final
disc (page 22).
• The tape deck stops automatically when the CD is finished.
To stop recording
• To add a 4 second silent inter\'al before stopping
Press ■. The CD will stop automatically too,
• To stop recording without a silent inter\'al
Press • REC/STOP. The CD will stop automatically too.
To Start recording on reverse side
Load a tape and change the tape direction as explained here below.
1. Press TAPE DECK 1/2 and select tape deck 2.
2, Press and immediately thereafter I. The tape direction will be
shown as '‘-M".
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
To record programmed tracks
1. After step 5, program the track you want (performs steps 2~6 on
page 26.)
2, Press • REC/STOP to start recording.