Panasonic SCAK50 - Manual (Page 10)

Ustening to mdimhroadeasts
Press TUNER BAND to select band.
The power will come on automatically.
Every time you press the button; FM ’ ► AM .
Press TUNE MODE to select “PRESET” or
“MANUAL”.
Every time you press the button; MANUAL + >■ PRESET.
PRESET; For preset stations
MANUAL: For non-preset stations
Press V or A to select the desired broadcast.
"STEREO" lights when an FM stereo broadcast is being
received. "TUNED" lights when you precisely tune in a
broadcast station.
Adjust the volume level.
Auto tuning
Auto tuning is an easy way to tune in non-preset stations {"MANUAL"
is displayed).
Hold down either V or A, and release the button when the
frequency starts ecrolling.
The radio will stop automatically on the first station it picks up.
• When there is outside interference, the radio may stop on a non­
broadcast frequency. Hold down either V or A to resume auto
tuning.
To stop auto tuning
Press either V or A again.
If noise is excessive in the FM stereo mode
Press FM MOOE/BP.
"MONO" will light up.
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. "MONO" will go out.
Normally, you'll want to listen in stereo, so leave "MONO" off. This
way, you can listen to stereo broadcasts in stereo, and monaural
broadcasts in mono,
•
• If you preset stations in memory, you can tune in a preset station
bv simply selecting the preset channel with the numeric buttons
on the remote control,
• Sound is momentarily interrupted if you load/unload tapes while
listening to an AM broadcast.