Panasonic Panafax UF-311 - Manual (Page 58)

During Reception
Problems
Print Copy Quality
Problems
Communication Problems
No unit operation
Symptom Action
Document Auto
reduction
doesn't work
1. Check if Fax Parameter No. 13 Recording Paper size
setting is set properly.
2. Check the Fax Parameter settings, see page 3-6
"Print Reduction".
Out of Ink
The information code 015 will appear on the display if
the Print Cartridge runs out of ink. To replace the
Print Cartridge, see page 7*9.
Print is too dark or too
light Try changing Fax Parameter No.14 Print Quality
Setting, see page 3-6.
Vertical Lines Printing on
the received Document
Printout a journal report (e g. CLEAR/COPY, 2 and
START) and check quality to make sure if your
machine has trouble or not.
If Journal report quality is OK, your machine has no
problem, report to sending party that they have a
problem,
tf copy is NG, Clean the Print Cartridge, see page 7-10.
Fuzzy Print
1. Make sure you are using the correct paper for the
best possible print quality. See page 8-2.
2. Try reversing the recording paper to the other side.
Missing Dots or Lines/
Inconsistent Darkness
within Print
1. Make sure you are using the correct paper for the
best possible print quality. See page 8-2.
2. Clean the Print Cartridge, see page 7-10.
3. Replace Print Cartridge, see page 7-9.
Fading Print Your print cartridge may be running out of ink.
Replace Print Cartridge, see page 7-9.
Faint Print
You may need to choose a different paper for the
best possible print quality. See 8-2.
No Dial Tone
1, Check the connection of telephone line.
2. Check the telephone line. See page 7-13.
No auto answer
1. Check the connection of telephone line.
2. Check Reception mode setting. See page 4-9.
3. Check if machine is printing or not. If machine is
printing received document from memory,
machine cannot receive until printing is completed.
Cannot Transmit or
receive
An information code will be shown on the display.
Refer to the information code table to find out the
trouble.
"POWER" LED is not lit
Check the connection of power cord and the position
of Power Switch.
No unit operation To reset the machine, turn off the Power Switch then
turn on again.