Panasonic Panafax UF-311 - Manual (Page 17)

2 . 6 -
CONNECTING THE
TELEPHONE LINE AND
POWER SUPPLY CORD
1. Plug the Telephone Line Cord into the Telephone Jack supplied by
the Telephone Company.
2. Plug the Power Supply Cord into an ordinary AC outlet.
3. Turn the Power Switch ON.
NOTE
1. When you operate this equipment^
the power socket/outietshouid be
near the equipment and be easily
accessible.
Notice To Users In New Zealand
1. Immediately disconnect the equipment should it become physical
damaged, and arrange for its disposal or repair.
2. Disconnect the telecom connection before disconnecting the
power connection prior to relocating the equipment, and
reconnect the power f i rst
3. This equipment may not necessarily provide for the effective hand­
over of a call to or from a telephone connected to the same line.
4. The operation of this equipment with audible warning devices or
automatic ring detectors will give rise to bell tinkle or noise and
may cause false tripping of the ring detector. Should such
problems occur, the user is not to contact telecom faults service.
5. If the supply cord of this appliance is damaged, it must be replaced
by the special cord supplied by a authorised Panasonic service
centre.
2 - 8