Panasonic Panafax UF-311 - Manual (Page 30)

4
.
1
.
2
.
BASIC TRANSMISSION
SETTINGS
You can temporarily change Resolution and Contrast settings before
any ordinary transmission.
These settings can be altered before or after you place documents on
the ADF. You can also change these settings during transmission, but
the change will notbecome effective until the machine starts
transmitting the next page
Resolution
NOTE
1. When trensmisshn ends, the setting
returns to the prese t se tting.
2. To change the preset Hesoiution
position, change Fax Parameter
No.01 setting, see page 3‘6.
Your machine is preset to Standard resolution, which is suitable for
ordinary documents. Use Fine for very detailed documents.
Press RESOLUTION button to :
RESOLUTIONS Standard
RESOLUTION = Fine
Original (Contrast)
Your machine is preset to Normal contrast. If you have to send a
document with Light contrast, it may be wise to change the setting to
Light. If you have to send a photographs or illustrations with grey
tones, it may be wise to change the setting to Halftone.
Press ORIGINAL button to;
NOTE
1. when transmission ends, the setting
returns to the preset setting.
2. To change the preset Contrast
position, change Fax Parameter
No.02 setting, see page 3-6.
3. You can verify ifdte transmission was
successful or not by printing out a
Communication Journal. Printout
condition can be selected
(ON/OFFUNC) by a fax parameter (see
page 3~B).
f
12-08-1992 12:00
NORMAL U6HT HALFTONE
i
12-08-1992 12:00
1--- ' I I
NORMAL LKHT HALFTONE
1
W-08-199^^^2^oJ
I
---- ' 1 I
NORMAL LIGHT HALFTONE
L
ORIGINAL = Normal
ORIGINALS Light
ORIGINAL» Halftone
4 - 3