Panasonic VideoCipher II Integrated Satellite Receiver/Positioner/Descrambler CRD-4500 - Manual (Page 7)

REAR CONTROLS AND TERMINALS [CRD-4500R]
© @
@ © 16 21
J
m
©
@ © @ -¿I,™ @ @ @ @
^ EXT ANT TV OUT ““ composite VIDEO AUDIO V-/
^------------ /©V---------- OUT OUT OUT
GNO V l HV i QH)
dual FEED CONTIOL
FROM POAiER UNIT
@ ©
ipPv d W a
vgTtZBaüg?
©i
c
25
/©N ^
n
'©
©
ITEM NO. PURPOSE
1^ UHF REMOTE ANT Connector for UHF antenna.
0
2ND IF LOOP Provides 510MHz (2nd IF) signal loop for optional Tl filter Installation.
©
IF IN/+18V DC
OUTPUT TERMINAL
Input connector for signal from-LNB. Also supplies power to the LNB.
©
COMPOSITE OUTPUT
TERMINAL
Composite baseband signal to other descramblers.
0
VIDEO OUTPUT
TERMINAL
Video signal to video monitor.
AUDIO OUTPUT
^ TERMINALS
Audio signal to stereo monitor.
16 METER ADJUST Normalizes the signal strength meter.
©
DUAL FEED CONTROL
TERMINALS
Control Voltages to V/H, Ku/C switch for Dual LNB System.
1^ IPPV
RCA-type connector for future applications.
(Pay per view subscription for special programs when available.)
© DATA
g| 25 PIN TERMINAL To connect the power cable from the power supply.
21
VIDEO SCAN
ON/OFF
Scans from the lowest frequency channel to the highest while in the “ON” position.
Use to locate satellites when moving anterira. Set Ku or C-Band as appropriate.
EXT. ANTENNA
^ TERMINAL
Input from external VHF antenna.
TV RF OUTPUT
^ TERMINAL
VHF signal to TV.
CHANNEL
M CH3/CH4
Selects Channel 3 or 4 output of CRD-4500 to the television.
Choose the channel that is not broadcast locally and tune TV to this channel.
VIDEOCIPHER
^ ADDRESS NO.
You can read the first 8 numbers of your Authorization (Address) Number through this
window. See page 23—26 for directions to read your full 12-digit number.
Use this No. for program subscription.
Note: □ Controls
n "■ Terminals
- 6 -