Panasonic SC-AK25 - Manual (Page 6)

Conneefsom
For Australia and NewZealand For others
Adhesive tape
FM indoor Antenna
Antenna holder
For Australia and
NewZealand
T-pFM ANT-
ip I gNO TS n
AM loop Antennas
For others
AM loop Antennal;
Appliance inlet —
approx. 6 mm
Connector
®P!ug the AC power cord into a household AC outlet only after ail
other connections have been made.
«To prepare the AM loop antenna wire and speaker cords, twist the
vinyl cover tip and puii off.
Connect the FM indoor antenna.
Tape the antenna to a wall or column, in a position where radio
signals are received with the least amount of interference.
: FioEÄusträ lia arid NéwZëatahdr
The configuration of the FM Antenna terminal is different.
For best reception sound quality:
An FM outdoor antenna is recommended. (See page?.)
Connect the AM loop antenna.
After attaching the antenna, turn on the system and tune in a
broadcast station. Then, turn the antenna to the angle of best
reception and least interference.
Connect the front speaker cables.
Caution
Use the speakers only with the recommended system.
Failure to do so may lead to damage to the amplifier and/
or the speakers, and may result in the risk of fire.
Consult a qualified service person If damage has oc-
curred or if you experience a sudden change In perfor­
mance.
Connect each end of the speaker cables to the terminal lever
of the same color.
When speakers are connected to the low and high termi­
nals on the back of the main unit
They are designed to have a combined impedance of 60.
Be sure to use only the speakers supplied.
impedance
Caution
•Never use speakers other than those supplied. For instance,
if you connect speakers with an impedance of 60 each and
plug them into the low and high terminais, you will only have
a combined impedance of 30.
•To prevent damage to circuitry, never short-circuit positive
(+) and negative (-) speaker wires.
71 Connect the AC power cord.
(United Kingdom only)
BE SURE TO READ THE CAUTION FOR
AC MAINS LEAD ON PAGE 4 BEFORE
PROCEEDING TO STEP
0.
Insertion of connector
Even when the connector is perfectly inserted, depending on
the type of inlet used, the front part of the connector may jut
out as shown in the drawing.
However there is no problem using the unit.