Panasonic SC-AK25 - Manual (Page 21)

Recording from radio broadcasts
Press DECK 2 ^ OPEN and insert the tape.
Close the holder by hand.
Tape direction is automatically set to
Except SG-yiK25imbde|Tdr Austria j ia;and:NeWZeal and;
Press DOLBY NR.
You have to turn Dolby NR ON/OFF according to the type of
recording you want to make.
Every time you press the button: □□ NR-i'(OFF)
t_^
Press REV MODE to select the reverse mode.
Every time you press the button:
'L.. ..... - . .1
:: One side is recorded, then recording stops auto­
matically.
D, Both sides (front side—»reverse side) are recorded,
then recording stops automaticaily.
Select a radio station. Perform steps 1 through
3 on page 12.
Press a REC/STOP to start recording.
If you selected in step 3, the direction will automatically
change to when recording starts.
To stop recording
Press • REC/STOP again.
Recording can also be stopped by pressing
To start recording on the reverse side
Load a tape and change the tape direction as following.
1. Press TAPE DECK 1/2 and select tape deck 2.
2. Press < and immediately thereafter B. The tape direction will be
shown as
To record from a specific point on a tape
Before recording, advance the tape to the point from where you
want to start recording.
To cut an unnecessary part while recording
1 . Press • REC/STOP during the unnecessary part. The cassette
deck will go into the stop mode.
2 . Press 9 REC/STOP to resume recording again.
Recording will continue in the same direction as before.
When recording an AM broadcast, sound is momentarily inter­
rupted when you start and stop the recording.
To reduce noise while AM recording
(Beat proof function) El
Press FM MODE/BP while recording.
Each time you press the button, BP 1 and BP 2 will be displayed al­
ternately.
Select the position where there is less noise.
■
I
o
u
&
I