Press tuner band to select band, Press tune mode to select “preset” or “manual, Press v or a to select the desired broadcast – Panasonic SC-AK25 User Manual

Page 12: Adjust the volume level, Auto tuning, If noise is excessive in the fm stereo mode el, Listening to radio broadcasts, F_f ). _f l.ì, Liif

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Listening to radio broadcasts

BAMD

i TUNER

J” /1

~i >~i

>11

f_f ). _f L.Ì

t i \

i~ i~ r~

r~ n

C lì

I—

»It n h I I t n I

I I ) I ) if U I t

liif

Press TUNER BAND to select band.

The power wiil come on automatically.

Every time you press the button;

Press TUNE MODE to select “PRESET” or
“MANUAL”.

Every time you press the button; “MANUAL”«—>“PRESET’.

PRESET: For preset stations

MANUAL: For non-preset stations

Press V or A to select the desired broadcast.

“STEREO” lights when an FM stereo broadcast is being re

ceived. “TUNED” lights when you precisely tune in a broadcast
station.

Adjust the volume level.

Auto tuning

Auto tuning is an easy way to tune in non-preset stations in the

“MANUAL" mode.

Hold down either

and release the button when the fre

quency starts scrolling.

The radio will stop automatically on the first station it picks up.

•When there is outside interference, the radio sometimes stops on

a certain frequency where no station is broadcasting.

To stop auto tuning

Press either v or

again.

If noise is excessive in the FM stereo mode El

Press FWI MODE/BP. “MONO" will light up,

Sound will be produced in monaural, but this also reduces noise.

Press the button again to cancel. “MONO” will go out.

Normally, you’ll want to listen in stereo, so leave “MONO" off. This

way, you can listen to stereo broadcasts in stereo, and monaural

broadcasts in mono.
You can preset an FM station monaural by following the steps under

“Presetting only your favourite stations” on page 11.

After selecting the station in step 1, select “MONO" with FM MODE/

BP, then continue with step 2 and 3.

•

• If you preset stations in memory, you can tune in a preset station

by simply selecting the preset channel with the numeric buttons on

the remote control.

1. Press TUNER on the remote control.

2. Press the numeric button{s) to select the desired channel.

Press

> 10

and then two numbers you want within 10 second or

so.

• Sound is momentarily interrupted if you load/unload tapes while lis

tening to an AM broadcast.