Panasonic SC-AK25 - Manual (Page 30)

Using the timer
To switch the timer OFF
Press ® PLAY/© REC and check "® PLAY” (for play timer) or
“® REC” {for record timer) goes out.
If you set the timer incorrectly
Repeat the procedure from step 1.
To check settings
Press CLOCK/TIMER to select “® PLAY" (for play timer) or
“© REC" (for record timer).
Two seconds later, the display will change in the following order.
«For play timer
® Play start time
(j) Play end time
(g) Play source and playback volume
«For record timer
® Recording start time
@ Recording end time
d) Recording source
You can check the settings even when the system is OFF.
To enjoy the desired source after the timer setting is com­
pleted
The volume level and music source are stored in the timer memory
and the timer will start in these preset conditions. However, the Disc
numbers, Dolby NR and reverse mode do not get stored in the timer
memory,
1. After step 6 , turn on the power and start playing the desired
source.
2 . Reset the Disc number, Dolby NR and reverse mode if you have
changed any of them, confirm that a Disc or cassettes is insert­
ed, then press power to put the unit on stand by.
Turning the timer ON/OFF
As long as “0 PLAY" or “© REC" is displayed, the timer wil! come
ON everyday as set.
You can turn the timer ON/OFF by pressing © PLAY/® REC while
the system is OFF.
Remember that when “© PLAY” or “© REC" is displayed, the timer
is ON. When not displayed, the timer is OFF.
smm
«If the power is on, the timer wili not function. The system must be
in the standby mode,
•if you switch the power to the standby mode while the play/record
timer is functioning, the OFF time setting will not be activated.
«If AUX is selected as the source, when the timer comes ON, the
system will turn ON and will engage “AUX” as the source. If you
want to playback or record from a connected component, set the
component’s timer to the same time. (See the instruction manual
that came with the component.)
«The play timer cannot be used in combination with the record
timer.