Panasonic SC-CH31 - Manual (Page 9)

Amplifier
■ Amplifier controls
® Power '*STANDBY(i)/ON'* switch and Indica­
tor (POWER, STANDBY c!)/ON)
Press to switch the unit from on to standby rr>ode or vice
versa. In standby mode, the unit is stili consuming a smail
amount of power.
•When the unit is connected to the AC mains supply, this
indicator lights up in standby mode and goes out when the
unit is turned on.
@ Equalizer controls
(GRAPHIC EQUALIZER LEVEL)
Use to adjust the equalization levei.
These controls are for compensation of tonal quality. By sliding
the controls at each of the indicated frequencies in the “+"
direction, the tonal quality is increased, and by sNding them in
t h e d i r e c t i o n , the tonal quality is decreased.
(See page 44.)
0 Super bass button (SUPER BASS)
Press to boost the dynamic low-frequency ranges.
0 Volume level control (VOLUME)
Turn to adjust the volume level.
When turning the controi, the alphanumeric display shows the
volume level.
Note that — dB is the lowest volume setting and 0 dB is the
highest.
(@ Volume preset button (VOL PRESET)
Use to preset volume for timer play.
® Remote control signal sensor (SENSOR)
Receives the signals from the remote control.
® Input select buttons (TAPE, AUX, CD, TUNER)
Press to select the sound source.