Panasonic SC-CH31 - Manual (Page 19)

Memory presetting
When you preset broadcast frequencies to the memory, you can
then easily select any of those broadcast frequencies by pressing
one of the preset-tuning buttons on the remote control or by using
the jog dial. You can input up to 40 radio stations (10 FM, 10 MW, 10 SW1 and
10 SW2) into the tuner’s preset memory [For Australia and New
Zealand, you can input up to 30 radio stations (10 FM, 10 LW,
10 MW) into the tuner’s preset memory.].
(When you memorize a new frequency on a preset channel, it
cancels the frequency previously memorized on that preset
channel.)
4-6
Switch on the power.
1
Press the band-select button to select FM,
MW, SW1 or SW2 (For Australia and New
Zealand, FM, LW, MW).
2
Press TUNING to select the MANUAL or AUTO
tuning mode.
•Every time you press this button, the MANUAL, PRESET
and (AUTO) modes altemately appear.
•AUTO wilt appear only when the FM mode is selected.
3
Tune In your favourite station using the jog
dial.
Turn the |og dial until the oonect frequency and the quartz lock
indicator appear on the display.
4
Press SET to activate the program indicator.
The program indicator will flash for about 10 seconds.
5
Turn the Jog dial to select the desired preset
channel while the program indicator Is
flashing.
; The channel number will increase from 1 to 10.
^ : The channel number will decrease from 10 to 1.
.c
f I
ouMmioat
00. 1 0 ...
m
Channel number
6 Press SET.
The program indicator will disappear.
7
Repeat steps 3 through
6
to memorize a sta­
tion In each of the remaining preset channels.
19